Solvey Galden HT-200 Heat Transfer Fluid for Etchers CVD PVD 5 Kg Bottle PFPE Fluid Pour point ＜-85
Specification:
Brand: Solvey Galden
Model: HT200
Place Of Origin: Itlay
Weight: 5KG
Bolling Point: 200℃
Pour point: ＜-85
OTHER SUPERIOR PRODUCTS
Yasakawa Motor, Driver SG- Mitsubishi Motor HC-,HA-
Westinghouse Modules 1C-,5X- Emerson VE-,KJ-
Honeywell TC-,TK- Fanuc motor A0-
Rosemount transmitter 3051- Yokogawa transmitter EJA-
Contact person: Anna
E-mail: wisdomlongkeji@163.com
Cellphone: +0086-13534205279
Similar Products
HT50
HT90
HT110
HT135
HT175
HT200
HT230
HT270
Available Properties
Density
Solubility of Water
Kinematic Viscosity
Kinematic Viscosity
Kinematic Viscosity
Molecular Weight, average
Vapor Pressure
Surface Tension
Volume Resistivity
Dielectric Constant
Dielectric Strength, 2.54 mm gap
Dissipation Factor
Heat of Vaporization, at boiling point
CTE, linear, converted from volumetric expansion of 0.0011 cm3/cm3-°C
Specific Heat Capacity
Thermal Conductivity
Boiling Point
Maximum Service Temperature, Air, as heat transfer fluid
Minimum Service Temperature, Air, as heat transfer fluid
Pour Point
Refractive Index
Fluorinated heat transfer fluids are among the most expensive in the chemical industry. Commonly associated with single phase heat transfer applications in the semiconductor manufacturing industry these materials are well-suited to a variety of semiconductor manufacturing heat transfer applications, such as etchers, ion implanters and teste
Other safe heat transfer media for demanding applications including:
Chemical
Pharmaceutical
Vapor phase heating
Transformer and super computer cooling
Recirculating chillers
Applications consist of component immersion, wafer etching, ion implantation, radar equipment, transformers, power supplies, UF6production, chillers, cooling towers, and freeze dryers.
Engineering Controls:
Ventilation Requirements: Local Exhaust:
Vent vapors or mists generated by processing away from operating personnel. Local exhaust ventilation at a rate of 50 feet per minute.
Personal Protective Equipment:
Respiratory Protection:
No occupational exposure standards have been developed for this material. In situations where exposure to vapors or mists is likely, NIOSH/MSHA approved respirators are recommended. Respirator use limitations made by NIOSH/MSHA or the manufacturer must be observed. Respiratory protection programs must be in accordance with 29 CFR 1910.134.
Eye Protection:
Eye/Face Protection: ANSI Z87.1 approved safety glasses with side shields or equivalent.
Skin Protection:
Rubber or latex recommended but not necessary.
3M/Fluorinert and Solvay Galden are the two market leaders. With few suppliers, consumers must be resourceful in how they buy, use and dispose of these valuable materials. The great news is that these materials can be reclaimed to their original state at fraction of the cost of new. Reusing inert heat transfer fluids many times gains greater cost efficiencies. Under most conditions you can expect 90% of the contaminated fluid returned to like new quality resulting in minimal hazardous waste disposal. Using reclaimed heat transfer fluids decreases downtime on equipment & significantly improves your MRO budgett.