Industrial Yaskawa Servopack SGDS-04F01A Servo Drive 400W 115VAC 1PH 9.4Amp

Media Darkness The ^MD (Media Darkness) instruction adjusts the darkness relative to the current darkness setting. The minimum value is -30 and the maximum value is 30. Examples for Using the ^MD Instruction If the current value (value on configuration label) is 16, entering the instruction ^MD-9 would decrease the value to 7. If the current value (value on configuration label) is 1, entering the instruction ^MD15 would increase the value to 16. If the current value (value on configuration label) is 25, entering the instruction ^MD10 would only increase the value to 30 since that is the maximum value allowed.

 

 

NOTE: Each ^MD instruction is treated separately with respect to the current value (value on configuration label). For example, this is what would happen if two ^MD instructions were received: Assume the current value is 15. An ^MD-6 instruction is received that changes the current value to 9. Another instruction, ^MD2, is received. The current value is changed 17. The two ^MD instructions were treated individually with respect to the current value of 15.

 

 

Label Top Position The ^LT (Label Top) instruction moves the entire label format a maximum of 64 dot rows up or down from its current position with respect to the top edge of the label (newer firmware versions allow dot rows to adjust +120 to -120; see the ^LT command on page 284). A negative value moves the format towards the top of the label; a positive number moves the format away from the top of the label. This instruction can be used to fine-tune the position of the finished label without having to change any of the existing parameters.