New and Original Yasawa Electric 50/60HZ Servo Motor 230VAC 100W SJDE-01ANA-OY

New and Original Yasawa Electric 50/60HZ Servo Motor 230VAC 100W SJDE-01ANA-OY
 

DESCRIPTION

• Industrial Servo Drive
• ServoPack 
• Servo Controller

SEPCIFICATIONS

Input Main Voltage: 200-230V
Input CONT Voltage: 200-230V
Input Mian PH: 1
Input Mian Frequency:50/60HZ
Input Mian Current : 1.3A
Input CONT Current : 0.25A
Output Power :100W
Output Voltage: 0-230V
Output Current: 0.84A
Output Frequency:0-300Hz
Output PH :3
Temperture: 0-55℃
Place of Origin:Japan
Efficiency:IE 1

SIMILAR PRODUCTS

SJDE-01APA

SJDE-02APA

SJDE-04APA

SJDE-04APA+SJME-04AMB41

SJDE-08APA

SJME-01AMA41

SJME-04AMA41

SJME-04AWA41

SJME-08AWA41

Installation

Install the board by placing it near the turnouts you want to control and the fascia where you want to mount the switches. The inputs are more susceptible to noise than the outputs, so keep the input wires shorter (less than 2 feet if possible) and allow the servo wires be longer in considering the placement.

Mount the board with a couple of wood screws through the mounting holes, or use double sided tape. In some cases you may just want to leave the board floating and tack down the wires around the board to keep it in place. Make sure to keep the board away from conductive surfaces such as metal that could short the board. You can kill the board if let a hot wire touch the wrong part of the board.

Make certain the voltage regulator is free to ventilate the excess heat. If the regulator gets too hot (~85C) it will shut down until it cools back down. The regulator will be warm in normal operation.

Power - Connect the board to a DC power supply in the range of 6 to 24 volts. The power supply should be rated 1 Amp or better. Budget 0.12 A (120 mA) per servo.

Power - Connect the board to a DC power supply in the range of 6 to 24 volts. The power supply should be rated 1 Amp or better. Budget 0.12 A (120 mA) per servo.

Servos

Plug the servos in to the bank of servo connection pins. Servos have three wires, the power leads are usually black and red, and the third, the signal lead is white, yellow or orange depending upon the brand. Plug the servos in so that the signal lead is inboard on the pins marked “S” and the black wire is towards the edge of the board on the row of pins marked “B”. If you do it incorrectly, it won’t hurt anything, but the servo won’t move. Please see the website for more information on mounting servos for driving turnouts. Also see the article in the July 2009 issue of Model-RailroadHobbyist online e-zine. There is a link to the article on the front page of the Tam Valley Depot website.

OTHER SUPERIOR PRODUCTS