New Yasawa Electric Servo drive Output 750W 0-230V 3.7A SJDE-02ANA 1Phase

New Yasawa Electric Servo drive Output 750W 0-230V 3.7A SJDE-02ANA 1Phase

DESCRIPTION

• Industrial Servo Drive
• ServoPack 
• Servo Controller

SEPCIFICATIONS

Input Main Voltage: 200-230V
Input CONT Voltage: 200-230V
Input Mian PH: 1
Input Mian Frequency:50/60HZ
Input Mian Current : 8.9A
Input CONT Current : 0.25A
Output Power :750W
Output Voltage: 0-230V
Output Current: 3.7A
Output Frequency:0-300Hz
Output PH :3
Temperture: 0-55℃
Place of Origin:Japan
Efficiency:IE 1

SIMILAR PRODUCTS

SJDE-01APA

SJDE-02APA

SJDE-04APA

SJDE-04APA+SJME-04AMB41

SJDE-08APA

SJME-01AMA41

SJME-04AMA41

SJME-04AWA41

SJME-08AWA41

Centering the Servos To aid in installation the servos can be driven to their center position. Place a jumper across the Center pins and the all 8 servos will move to their center positions. The servos will stay centered until the jumper is removed.

Automatically Aligning the Servos Follow these steps to align the servos automatically. • Connect the servo to the OctoIII before mounting it. • Connect the Remote Alignment board with the flat cable. • Put the Run/Align jumper on the OctoIII to the Align position. • Put on the Center jumper • Mount the servo such that the points are midway between the stock rails • Remove the Center jumper • On the Remote Alignment board: • Use Next to set the the same number as the servo on the remote. • Press Next/Auto for ~ 1 sec • Choose the force level with the <--- and ---> buttons. • Press Next briefly to start the alignment search The LED will flash rapidly for about 2 minutes while the servos are aligned (To abort press Next briefly.) • If desired, swap the endpoints with a brief push of Swap. (This will be needed if your controller indicates Close when the turnout is actually Thrown.)

If the servos stop before the desired inputs, check that the points are free to move and that there are no obstructions to the actuating mechanism. You can also redo the auto-alignment and increase the force on the points at the start of the alignment. If the points have too much force on them try a lower number. It is best to use just enough force to reliably align the points but no more. If the servos make a grinding noise at the end of the throw then this is an indication to lower the auto-align force OR you can tweak the force manually (see Manual Alignment).

OTHER SUPERIOR PRODUCTS