|
|
|
Sales & Support 86-755-25020661
Request A Quote - Email Select LanguageEnglish
French
German
Italian
Russian
Spanish
Portuguese
Dutch
Greek
Japanese
Korean
Indonesian
Bengali
|
Product Details:
Payment & Shipping Terms:
|
| Brand: | GE Fanuc | Model: | IC697CGR935 |
|---|---|---|---|
| Series: | Series 90-70 | Product Type: | CPU |
| Memory Capacity: | 1MB | Memory Type: | CMOS RAM |
| Current: | 3.1 A | Temperature: | 0 To 50 Degrees Celsius |
| Communication: | RJ 45 | Warranty: | 1 Year |
| Highlight: | 24v DC Negative Logic Output Module,PLCs Digital Servo Module,5V DC Digital I O Module |
||
The IC697CGR935 module is a one slot controller in the GE Fanuc series, which permits fluctuating point calculations mandatory for CPU redundancy applications. The IC697CGR935 module in the Redundancy System is used as the controller. There are two control methods to note when using the IC697CGR935. In the GHS process, several single bus networks with one redundant controller are used in each synchronized PLC. When using the GDB process, multiple I/O networks are used with single or double buses in each synchronized PLC. Each control method can be easily activated and used without difficulty. In the IC697CGR935 module, the memory board delivers data, and program memory is included with the module. The IC697CGR935 can be operated remotely or by the three position RUN/STOP switch. Positioned on the front of the module are the LEDs, which specify the status of the CPU.
Installation of the IC97CGR935 module should not be attempted without referring to the appropriate Programmable Controller Installation and Hot Standby CPU Redundancy Manual. The battery should be connected to one of the module’s battery connectors. The key switch should be positioned to MEMORY PROTECT OFF, and there should be no rack power. Once module is installed in slot 1 of rack 0, power is turned on. The top LED should blink indicating that the IC697CGR935 module is powered up. Once the diagnostic is finished effectively, the top left LED stays on while the second and third LED will be off. The MEMORY PROTECT LED which is the fourth LED, is off because the key switch is in off position. Programming is now ready for the CPU. The CPU can be programmed regardless of the placement of the key. Once the program has been confirmed, the toggle switch can be positioned in the appropriate operational mode.
| Module Type: | Single Slot CPU |
| Operating Temperature: | 0 to 60 deg C (32 to 140 deg F) |
| Battery Shelf Life: | 5 years at 20 deg C (68 deg F) |
| Inputs and Outputs: | 12K each (any mix) |
| Serial Ports: | 3 |
| Current Required: | 3.1 Amps nominal |
|
Battery Shelf life Memory retention |
5 years at 20o C (68o F) 6 months nominal without applied power. |
| Current required from 5V bus | 3.1 Amps nominal |
| Operating Temperature |
0 to 60oC (32oF to 140oF); 70 CFM forced air required 0 to 50oC (32oF to 122oF); without forced air |
|
Time of Day Clock accuracy Elapsed Time Clock (internal timing) accuracy |
" 3.5 seconds per day maximum " .01% maximum |
|
Serial Ports Port 1: RS-232 compatible Port 2: RS-485 compatible (optocoupler isolated) Port 3: RS-485 compatible (not isolated) |
Programmer Serial Attachment, or other serial devices. Protocols supported: SNP Slave only |
Contact Person: Mayne
Tel: +86 13170829968