Small Industrial Servo Motor With Brake 100W 89A 3000RPM SGMPH-01AAA41

AC Servo Motor New SGMPH-01AAA41 (with Brake) Yaskawa 100 W  89A  3000RPM

QUICK DETAILS

1. Power : 100W
2. Voltage :200V
3. MaX Speed  : 3000RPM

DESCRIPTION

• Yaskawa Motor
• Servo Motor
• AC Servomotor

SEPCIFICATIONS

IMPORTANT

1. Wire sizes were selected for three cables per bundle at 40°C (104 °F) ambient temperature with the rated current.

2. Use cable with a minimum dielectric withstand voltage of 600 V for main circuits.

3. If cables are bundled in PVC or metal ducts, consider the reduction ratio of the allowable current

4. Use heat-resistant cable under high ambient or panel temperatures where normal vinyl cable will rapidly deteriorate.

5. Use cable within the allowable moment of inertia.

6. Do not use in continuous regenerating mode.

The magnetic contactor is manufactured by Yaskawa Controls Co., Ltd. Contact your Yaskawa representative for details. A magnetic contactor is required to make the AC power to SERVOPACK ON/OFF sequence externally. Be sure to attach a surge protector to the excitation coil of the magnetic contactor. Refer to 4.4.11 Surge Protector for details of the surge protector. For selecting a magnetic contactor, refer to 2.5.3 Noise Filters

Manufactured by Yaskawa Controls Co., Ltd. Contact your Yaskawa representative for details. If necessary for harmonic suppression, connect an AC reactor to the AC line for the single-phase input, a DC reactor between the SERVOPACK main circuit terminals 1 and 2 for the three-phase input. Select a reactor that matches the ratings of the SERVOPACK. For wiring, refer to 5.4.5 AC/DC Reactor for Harmonic Suppression.

CAUTION

• Do not bundle or run power and signal lines together in the same duct. Keep power and signal lines separated by at least 30 cm (11.81 in). 
• Use twisted-pair wires or multi-core shielded-pair wires for signal and encoder (PG) feedback lines. The maximum length is 3 m (118.11 inches) for reference input lines and is 20 m (787.40 in) for PG feedback lines. 
• Do not touch the power terminals for five minutes after turning power OFF because high voltage may still remain in the SERVOPACK. Make sure the charge indicator is out first before starting an inspection.
•  Avoid frequently turning the power ON and OFF.
• Do not turn the power ON or OFF more than once per minute. Since the SERVOPACK has a capacitor in the power supply, a high charging current flows for 0.2 seconds when the power is turned ON. Frequently turning power ON and OFF causes main power devices like capacitors and fuses to deteriorate, resulting in unexpected problems.

SIMILAR PRODUCTS