Contact person: Anna
E-mail: wisdomlongkeji@163.com
Cellphone: +0086-13534205279
Similar Products
140XTS01209
140XTS01212
140XTS10206
140XTS10215
140XTS33200
141MMS42501
141MMS53502
490NAA27101
490NAA27102
490NAA27103
490NAA27104
490NAA27106
490NAC72100
490NAD91103
490NAD91104
490NAD91105
490NAE91100
490NOC00005
490NOR00005
490NOT00005
490NRP25300
490NRP25400
490NRP95400
490NTC00005
490NTC00005U
490NTC00015
490NTC00015U
490NTC00040
490NTC00040U
490NTC00080
490NTC00080U
490NTRJ11
490NTW00002
490NTW00002U
490NTW00005
490NTW00005U
490NTW00012
490NTW00012U
490NTW00040
490NTW00040U
490NTW00080
The following diagram shows the register of the second input word. Bit 15 set to 1 means that there is an overload problem on channel 1, bit 14 set to 1 means that there is an overload problem on channel 2, and so on
NOTE: In case of activation of the overload bit, the corresponding output is automatically switched to the OFF state by the module (disjunction) and maintained
OFF during at least 10 seconds. To recover the control of the output, it is necessary to set by application the overloaded output command of the module to the OFF state.
Addressing
The following information describes how the data exchanged between the
140 SDO 953 00S module and the processor module are mapped.
Except for the health word, the data described here are transferred to and from the
140 SDO 953 00S module using the Quantum global backplane communication
access mechanism which is common to all Quantum modules.
NOTE: The words "input" and "output" used here are defined with respect to the
processor module.
11 words are necessary for this module:
? 4 words dedicated to output data
? 1 dedicated to channel values
? 3 words used by the module (exchange number, CRC)
? 6 words dedicated to inputs data:
? 1 dedicated to energized/de-energized channel detection
? 1 dedicated to overload errors
? 1 dedicated to unsafe channel errors
? 1 dedicated to process power supply status, malfunction from the host (and
exchange number which is used by the module)
? 2 words used by the module (CRC)
? 1 health word (this word is accessible by the processor module only)
The following figure shows the wiring diagram for the 140XBP01000 module
power supply: 24 VDC
fuse: 10 A max (determined by the module load current), fast blow
pre-act: pre-actuator
NOTE: There is only one group of 16 outputs. All common 24 V are internally
connected and all common 0V are also internally connected. For safety applications,
it is recommended to connect at least 2 ground lines (common 0V) to the field wiring
terminal block. The two pins of a same input (e. g: pin 1 and 2 for input 1) are
internally connected too so that you can use either the right pin or the left one