One new Yaskawa 1.8A 1.27N.m servo motor SGMAS-C2ACA21-Y2 Industrial Servo Motor

One new Yaskawa 1.8A 1.27N.m servo motor SGMAS-C2ACA21-Y2 Industrial Servo Motor

SPECIFITIONS

Model Number:SGMAS-01A2A-YR11
Type: Servo Motor
Frequency: 50/60Hz
Output Power: 150W
Protect Feature:Totally Enclosed
Phase:Three-phase
Certification:CCC, CE, ROHS, UL, VDE, Other
AC Voltage:208-230 / 240 V
Place of Origin:Japan
Efficiency:IE 1

OTHER SUPERIOR PRODUCTS

Similar Products

3) Others
When using heat generating equipment such as the regenerative brake option, install them with full consideration of heat generation so that the servo amplifier is not affected.
Install the servo amplifier on a perpendicular wall in the correct vertical direction.

2.3 Keep out foreign materials
(1) When installing the unit in a control box, prevent drill chips and wire fragments from entering the servo amplifier.
(2) Prevent oil, water, metallic dust, etc. from entering the servo amplifier through openings in the control box or a fan installed on the ceiling.
(3) When installing the control box in a place where there are much toxic gas, dirt and dust, conduct an air purge (force clean air into the control box from outside to make the internal pressure higher than
the external pressure) to prevent such materials from entering the control box.

Bracket-Type
Bracket-type motors have their bearings mounted in a bracket that is attached to the motor frame. These primarily employ grease lubricated cylindrical roller bearings and do not require bedplates. The end covers are removable for easy access.

Pedestal-Type

Most large DC motors use the pedestal type of construction, which includes a bedplate on which the stator frame and bearing pedestals are mounted. The bedplate maintains the alignment between the armature and stator. A portion of the motor frame extends below the bedplate, and therefore, requires a pit under the motor. Removable end covers alloweasier access than bracket-type configurations.

Laminated, rectangular copper conductors are individually insulated and bonded together with separators. The formed, full coils are wrapped and taped with ground wall insulation. A protective binding of tape then covers the complete coil. After winding, multiple coats of insulating resin are applied to create a smooth surface that resists rust, moisture, chemical contamination and heat.