1PCS Industrial Servo Motor SGMG-05A2AC Yaskawa SERVO MOTOR 1 year Warranty

 

If a new motor mount is required and the legs do not line up with the original holes in the blower housing, it is required to use a bolt with either a lock washer and nut or a locking nut through the new drilled hole(s). Self tapping or sheet metal screws are not a sufficient long term installation when a new hole is drilled through the thin wall of the blower housing.

 

 

When positioning the legs of the bellyband on the motor, make sure that once the motor is mounted into the blower section, the wires come out towards the bottom of the motor as installed in the air handler. This will ensure that a proper drip loop can be made with the signal and power lines.

 

 

The blower wheel should be centered in the blower housing. The wheel should also not be resting up against the motor bearing housing. If this is not possible while centering the wheel the motor should be adjusted in the belly band. If the blower wheel is dirty, it should be cleaned.