Industrial 400W Yaskawa Servo driver Input 200-230V 1Phase SJDE-04ANA

Industrial 400W Yaskawa Servo driver Input 200-230V 1Phase SJDE-04ANA

DESCRIPTION

• Industrial Servo Drive
• ServoPack 
• Servo Controller

SEPCIFICATIONS

Input Main Voltage: 200-230V
Input CONT Voltage: 200-230V
Input Mian PH: 1
Input Mian Frequency:50/60HZ
Input Mian Current : 4.8A
Output Power :400W
Output Voltage: 0-230V
Output Current: 2.0A
Output Frequency:0-300Hz
Output PH :3
Temperture: 0-55℃
Place of Origin:Japan
Efficiency:IE 1

SIMILAR PRODUCTS

SJDE-01APA

SJDE-02APA

SJDE-04APA

SJDE-04APA+SJME-04AMB41

SJDE-08APA

SJME-01AMA41

SJME-04AMA41

SJME-04AWA41

SJME-08AWA41

� Voltage Voltage Voltage Voltage of power supply is AC220V~250V. AC220V~250V. AC220V~250V. AC220V~250V. � The servo motor can not be connected connected connected connected to municipal municipal municipal municipal power grid directly directly directly directly Servo motor can not be connected to municipal power grid directly; otherwise the motor will be damaged. Servo motor can not rotate without servo driver.

■Do not plug in or draw out of socket during electrification electrification electrification electrification Plugging in or drawing out of socket can be carried out after power down.

■Please carry out checking checking checking checking after 5 minutes minutes minutes minutes after power down Even the power is down, there is still electricity remaining in capacitors of servo driver. In order to prevent electric shock, test is carried out after a confirmed minute.

■Distance Distance Distance Distance with other equipment equipment equipment equipment is over 10mm The transverse distance with other equipment shall over 10mm and vertical distance shall over 50mm for installation. Servo motor gives heat such that the installation shall in accordance with the layout that is favorable for heat emission, and it shall be installed in the environment free from influence of dewing, shock and impact

■Anti-interference Anti-interference Anti-interference Anti-interference process process process process and grounding grounding grounding grounding If there is interference on signal lines, vibration and abnormal operation may be caused. Following stipulations shall be strictly complied:

a. Strong current signle and weak current signle shall be separated.

b. Wiring distance shall be shortened as most as possible.

c. servo motor and servo driver connect to GND through 100Ω resistance.

d. Don’t used interference filter between motor and servo driver.

OTHER SUPERIOR PRODUCTS