SGM-08A314 800W 200V Ins B YASKAWA High Torque Industrial Servo Motor For Cnc Machine

SGM-08A314 800W 200V  Ins B  YASKAWA High Torque Industrial Servo Motor For Cnc Machine 

SGM-08A314 800W Item Description

• Manufacturer: Yaskawa
• Model:  SGM-08A314
• AC Servo Motor
• RPM: 1500
• 800W
• 4.4A
• 3000RPM
• Ins F
• original made in Japan
• ac servo motor
• with connectors and cable

• Function:Control

OTHER SUPERIOR PRODUCTS

The following procedure is a supplement to other documentation supplied with this equipment and will guide the user in properly wiring the V1000 and motor. It will also allow the installer to check motor direction, correct if necessary and perform a motor Auto-Tune.

DANGER: Improper wiring can and will cause bodily harm as well as damage to the equipment.

When installing the system be sure to follow good wiring practices and all applicable codes. Ensure that the mounting of the various components are secure and that the environment, such as extreme dampness, poor ventilation etc. will not cause system degradation.

Question: How do I reset the drive back to factory default settings?

Answer: Go to parameter A1-03 and set value 2220 for 2 wire control or 3330 for 3 wire control (Please refer to Step 6 for wiring diagram)

Question: How do I adjust the time it takes the motor to speed up or slow down?

Answer: Adjust the acceleration time parameter C1-01 and deceleration time C1-02.

Question: How do I prevent my drive from tripping on an OV fault (overvoltage) while my motor is ramping down?

Answer: Increase deceleration time parameter C1-02.

Question: How do I prevent my drive from tripping on an OL1 fault (overload) while my motor is ramping down?

Answer: Verify motor rated current parameter E2-01 and motor overload parameter settings L1-01 Motor overload selection, L1-02 Motor overload protection time.

Question: I want to run my motor above the nominal motor speed?

Answer: Increase the value of parameter E1-04 Maximum Frequency